Processor Module Switch Settings - Digital Equipment Digital Server 3220 Series System Reference Manual

Technical Specifications

Processor Module Switch Settings

The following table lists the switch settings of various processor speeds and does not
indicate processor availability. The switches are set correctly for the processor that
came with the server you purchased. You only need to change the processor switch
settings, that is SW1, should you upgrade to another processor. Figure A-2 shows
the switch locations.
Processor Speed
350 MHz
400 MHz
450 MHz
ON = switch down; OFF = switch up
A-10
CAUTION:
Do not touch any electronic component unless
you are safely grounded. Wear a grounded wrist strap or
touch an exposed metal part of the server chassis. A static
discharge from your fingers can result in permanent
damage to electronic components.
SW1-1
OFF
ON
OFF
SW1-2 SW1-3
OFF ON
ON OFF
ON OFF
SW1-4
ON
ON
ON