Installing Dimms On The Processor Module - Digital Equipment Digital Server 3220 Series System Reference Manual

Installing DIMMs on the Processor Module

Use the following procedure to install DIMMs:
1. Power down your server.
2. Remove the side panel or top cover.
Refer to Chapter 3, "Server Components," for more information.
3. Remove the processor module.
4. Unpack the DIMMs. Refer to "Memory Configurations" described earlier in
this chapter for information on the supported memory configurations.
5. Install DIMMs starting with the next available Bank on the processor module,
orient the DIMM so that the two notches at the bottom edge of the DIMM are
aligned with the keyed socket (see Figure 6-2).
CAUTION
To avoid possible damage to the
:
components, place the antistatic wrist strap on your wrist
and connect the grounding clip to a non-painted metal
surface of the server's chassis.
Installing Additional Memory
6-5