Installing A Full-Height 5¼-Inch Device Into The Front Access Drive Bay - Digital Equipment Digital Server 3220 Series System Reference Manual

Installing Storage Devices (DIGITAL Server 3220R)
Installing a Full-Height 5¼-Inch Device into the Front Access
Drive Bay
To install a full-height 5¼-inch device into the front access drive bay slots, perform
the following:
1. Turn off your server.
2. Remove the front bezel.
3. Remove the screws securing the server to the rack and then slide it out.
4. Remove the screw securing the top cover to the server.
5. Remove the top cover.
6. Disconnect the power and data cables from the diskette drive.
7. Remove the bracket from the drive bay (inside, bottom) and attach it to
device (see Figure 9-3).
8. Remove the divider plate from between the two right-most drive bays.
9. Secure the device to the slot using the supplied mounting screws.
10. Replace the diskette drive.
11. Connect the power and data cables to the diskette drive.
Refer to Chapter 11, "Connecting SCSI Devices and RAID Adapters," for power
and SCSI cable connections.
9-6