Raid Cable Configuration - Digital Equipment Digital Server 3220 Series System Reference Manual

Connecting SCSI and RAID Devices

RAID Cable Configuration

To connect SCSI devices using a RAID adapter, perform the following:
NOTE:
and three-channel RAID adapters. Contact your DIGITAL
sales representative for more information.
1. Power down the server.
2. Disconnect all peripheral devices from the server.
3. Remove the access panel(s).
4. Connect the cables as shown in Figure 11-2.
Use the nylon cable clamps to dress the cables properly. Do not block the
air flow from the fan (if present).
5. Replace the access panels.
6. Connect all external devices and then power on your server.
7. Run the SCSI and/or RAID utilities to configure your server.
Refer to Chapter 2, "Server Software and Utilities," and to your SCSI and RAID
documentation for additional configuration information.
11-4
Your DIGITAL Server also supports two-channel