Installing Storage Devices (Digital Server 3220); Introduction; Installing A Half-Height 5¼-Inch Device Into The Top Drive Bay - Digital Equipment Digital Server 3220 Series System Reference Manual

Introduction

Your DIGITAL Server 3220 has two drive bay areas:
•
Top drive bay area—This area has one 5¼-inch IDE CD-ROM drive, one 3½-
inch diskette drive (both standard) and room for two 5¼-inch half-height SCSI
devices or one full-height, 5¼-inch device.
•
Hot swap (lower) drive bay area—This area has room for four 3½-inch wide
SCSI Storage Building Block (SBB) devices capable of "hot swapping,"
exchanging the device while the server is powered on and not accessing the
device.
Installing a Half-Height 5¼-Inch Device into the Top Drive Bay
To install a half-height 5¼-inch device into one of the top drive bay slots, perform the
following:
1. Turn off your server.
2. Disconnect all external devices, ac power, and monitor power.
3. Unlock and open the front bezel, loosen the thumbscrews, and remove the
side panel.
4. Remove the front plastic filler panel.
Installing Storage Devices
(DIGITAL Server 3220)
8
8
8-1