Installing Additional Memory; Introduction - Digital Equipment Digital Server 3220 Series System Reference Manual

Introduction

Your server supports 168-pin DIMM memory modules that use registered
Synchronous Dynamic Random Access Memory (SDRAM) technology. Your server
requires at least 64 MB of memory. Adding more memory enables your server to run
larger, more complicated software and run it more quickly. Registered SDRAM
DIMMS are available in 64 MB, 128 MB and 256 MB sizes to expand your server
memory up to 1GB.
Server memory is installed using the four DIMM sockets located on the processor
module, as shown in Figure 6-1.
When adding memory, make sure you reference the memory configuration table and
follow the memory expansion guidelines.

Installing Additional Memory

CAUTION:
DIMMs must be ordered separately. Only
install DIMMs supported by Digital Equipment
Corporation. DIGITAL does not support server
performance, product warranty, or service calls resulting
from installing non-qualified DIMMs.
6
6
6-1