Installing The External Wide Scsi Cable Assembly - Digital Equipment Digital Server 3220 Series System Reference Manual

Installing Storage Devices (DIGITAL Server 3220)

Installing the External Wide SCSI Cable Assembly

To connect the external wide SCSI cable assembly:
1. Power down the server.
2. Unlock and open the front bezel, loosen the thumbscrews, and remove the
side panel.
3. If processor 2 (CPU2) is installed, you need to remove the processor module
to gain access to the SCSI channel 2 connector on the main logic board.
4. Connect one end of the external wide SCSI cable assembly to the SCSI
channel 2 connector on the main logic board.
5. Remove any cover plate from the appropriate SCSI knockout at the rear of
the server.
6. Remove one of the hex-head screws from the end of the external wide SCSI
assembly and then loosen the other.
7. Thread the cable through the nylon cable clamps at the top of the chassis
divider. Do not block the air flow from the fan.
8. Insert the cable connector through the knockout and secure it in place with
the hex-head screws.
9. Continue with connecting an "External SCSI Storage Box" described later in
this chapter. Otherwise, attach a terminator to the external wide SCSI
connector at the rear of the server.
8-10