Installing A Full-Height 5¼-Inch Device Into The Top Drive Bay - Digital Equipment Digital Server 3220 Series System Reference Manual

Installing Storage Devices (DIGITAL Server 3220)
Installing a Full-Height 5¼-Inch Device into the Top Drive Bay
To install a full-height 5¼-inch device into the top drive bay slots, perform the
following:
1. Turn off your server.
2. Disconnect all external devices, ac power, and monitor power.
3. Unlock and open the front bezel, loosen the thumbscrews, and remove the
side panel.
4. Remove the front plastic filler panels.
5. Attach the supplied drive brackets to the device.
a. Ensure that the tab on the left bracket is up (A, Figure 8-2) and the
tab on the right bracket is down.
b. Install two screws in the front holes (B, Figure 8-2) and in one rear
slot. (When installed, the labeling on the right bracket will be upside
down.)
6. Insert the device into the drive bay from the front.
7. Secure the device using the supplied mounting screws.
Refer to Chapter 11, "Connecting SCSI Devices and RAID Adapters," for power
and SCSI cable connections.
8-4