Connecting The External Wide Scsi Cable Assembly - Digital Equipment Digital Server 3220 Series System Reference Manual

Installing Storage Devices (DIGITAL Server 3220R)

Connecting the External Wide SCSI Cable Assembly

To connect the external wide SCSI cable assembly:
1. Power down the server.
2. Remove the front bezel.
3. Remove the screws securing the server to the rack and then slide it out.
4. Remove the screw securing the top cover to the server.
5. Remove the top cover.
6. If processor 2 (CPU2) is installed, you need to remove the processor module
to gain access to the SCSI channel 2 connector on the main logic board.
7. Using a screwdriver, gently pry away the appropriate SCSI knockout located
at the rear panel (A, Figure 9-7).
9-14