Mounting To The Corner Of A Building - Mobotix D12 Manuals

D12 Camera Manual Part 1

2.11.1 Mounting to the Corner of a Building

Use the dowels, screws and washers supplied with the Outdoor Wall Mount
(see section 2.9, Delivered Parts of the Outdoor Wall Mount ) to mount the Outdoor
Wall Mount to the corner of a building.
• Mark the four holes for dowels at the corner
(make sure that the arrows in the mount point
to the top) and drill the holes using a 10 mm
(3/8 in) drill bit for walls.
• Guide the camera cables through one of the
large round holes at the back of the Corner
and Pole Mount, then through one of the
holes with 16 mm (5/8 in) diameter. In order to
properly protect the cabling, you should let
the cabling run from the inside of the building
through the Corner and Pole Mount directly
into the camera.
Note: The cable to the camera should be
running at least 80 cm (30 in) outside of
the corner!
• Insert the supplied 10 mm dowels (item 15)
into the dowel holes, then mount the Corner
and Pole Mount to the corner of the building
using the 8x70 mm screws (item 17) and
9 mm dia. washers (item 16).
Next, mount the Outdoor Wall Mount to the Corner and Pole Mount, as de-
scribed in section 2.11.3, Mounting the Outdoor Wall Mount to the Corner and Pole
Mount .
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
59
/124
Make sure arrows are
pointing upwards when
mounting!
Make sure not to squeeze
and damage the cables
when mounting!