Indoor/Outdoor Mounting Instructions; Mounting Indoor Cameras To A Wall Or Ceiling - Mobotix D12 Manuals

54
/124
Find the folded drilling
templates at the end of
the manual!
Make sure that the drill-
ing template is not scaled
down when printing!
D12 Camera Manual Part 1

2.8 Indoor/Outdoor Mounting Instructions

2.8.1 Mounting Indoor Cameras to a Wall or Ceiling

In order to mount the MOBOTIX D12 to a ceiling or wall, you need to drill the holes
for the fixtures. Use the supplied drilling template to mark the position of the holes
for the fixtures and the holes through which the cables will be led later on. Re-
member to position the drilling template according to the direction of the
camera's PIR sensor.
Planning and Connecting the CAT 5 Cable
(1) Position the camera housing over the cable exit.
(2) Lead the cables through the appropriate holes in the housing.
(3) Properly lead the cable(s) through the cable guides at the outer rim of the
housing.
(4) Use the proper screws to mount the camera housing to the wall or ceiling.
Make sure that the cable length is appropriate.
Check the following figure to see how the cables
are running properly. Cable length should be
50 cm (20 in) when mounting the D12 and
(28 in) when mounting the D112 with Outdoor wall
mount, always measured from the wall. There are
two ways to accommodate cable that is too long
(see figures):
(1) Loop near the RJ45
connectors
(2) Loop beneath the cam-
era
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
Note
80 cm
(2)
(1)
www.mobotix.com • sales@mobotix.com