Overview Of The Configuration Settings - Mobotix D12 Manuals

86
/124
Always use Quick Instal-
lation for initial configu-
ration!
Configuring the image
sensors:
Admin Menu > Quick In-
stallation or
Admin Menu > Image
Sensor Configuration
Admin Menu:
User: admin
Password: meinsm
Setup Menu
D12 Camera Manual Part 1

3.2 Overview of the Configuration Settings

• Using the Quick Installation wizard
After first booting the camera or after resetting it to factory defaults, any ac-
cess to the administration menu (Admin Menu button) will start the Quick In-
stallation.
This wizard will guide you through the most important settings of the camera
(configuration of the network interface, image control, etc.) and can also be
used to reset the camera to its factory settings.
Configuring the installed image sensors is an important step when configur-
ing the camera for the first time (color or black & white; D12D only, not re-
quired for D12D-180° or D12M-CS), which is either accomplished in the
Quick Installation wizard or manually by opening Admin Menu > Image
Sensor Configuration (see section 2.5, Installing the Lens Units (D12D Stan-
dard) ).
It is also recommended to use Admin Menu > Quick Installation later on as
well, e.g. if you would like to change connection parameters or add a new
connection type.
• Administration and setup of the camera
Basic configuration tasks of the camera (e.g. passwords, interfaces, software
updates) are carried out from the administration menu (Admin Menu button)
which requires the corresponding access rights ( admins group).
Open the Setup Menu (button) and find the dialogs for changing the image,
event and recording settings in the Image Control and Event Control sec-
tions. These options are also available for users belonging to the users
group.
Some of these settings can be changed using the corresponding pull-down
menus above the image on the Live screen.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com