Mounting The Camera On The Bottom Plate - Mobotix D12 Manuals

66
/124
Mount the camera housing
to the bottom plate be-
fore mounting the bottom
plate itself
PIR sensor of the camera
looks straight ahead:
Position 1
D12 Camera Manual Part 1

2.12.4 Mounting the Camera on the Bottom Plate

In order to mount the camera to the bottom plate, use three of the supplied Allen
screws M4x25 mm (item 21), three washers Ø 4,3 mm (item 22) and the corre-
sponding hex nuts.
When fastening the Allen screws using the 3 mm Allen wrench,
make sure that you do not scratch the camera dome!
• Guide the connector cables of the camera from below (smooth side)
through the round opening of the bottom plate (item 14).
• Position the camera on the underside of the bottom plate so that the PIR sen-
sor points in the desired direction and the hole in the housing to the right of
the PIR sensor is situated above a hole in the bottom plate.
• Insert the first M4 hex nut (item 20) into the corresponding hole of the bot-
tom plate, then use one Allen screw M4x25 mm (item 21) and a washer Ø
4.3 mm (item 22) and lightly fasten the screw.
• Turn the bottom plate around and determine the number next to the hex nut
you just inserted (example: PIR points
straight ahead
the number 1). Insert the remaining
M4 hex nuts (item 20) into the other
holes with the same number
case) and use the two Allen screws
M4x25 mm (item 21) with the corre-
sponding washers to mount the cam-
era to the bottom plate.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
Caution
hole should have
(1 in this
www.mobotix.com • sales@mobotix.com