Dismantling The Camera - Mobotix D12 Manuals

70
/124
Tighten the dome by turn-
ing clockwise
Align the mark of the
dome with the PIR sensor
The outer shell snaps into
its seats at the camera
housing by pressing gently
down on the ring
Dismount the outer shell
using the supplied custom
tool (see section 2.14, Dis-
mantling the Camera ).
D12 Camera Manual Part 1

2.14 Dismantling the Camera

Start dismantling the camera by removing the outer shell of the D12. For removing
the outer shell of the D12, you need the supplied custom tool; for dismounting the
dome, a lint-free cotton cloth is required (see section 2.15, Cleaning Instructions ).
(1) Remove the outer shell
For security reasons, the outer shell can only be removed using the supplied
custom tool. Proceed as shown in the figure below:
• Remove the outer shell using the supplied custom tool. Insert the tip of the
custom tool into the three small holes of the shell, one by one. Gently lift
the shell near each hole to loosen the shell.
• Remove the outer shell from the camera.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
Custom tool
www.mobotix.com • sales@mobotix.com