Mounting To A Concrete Or Brick Wall - Mobotix D12 Manuals

78
/124
Find the drilling template
at the end of the manual
Max. torque for all
screws: 4 Nm
(2.95 lbf ft)
D12 Camera Manual Part 1

2.16.3 Mounting to a Concrete or Brick Wall

Use the supplied materials and suitable tools for mounting the camera to a con-
crete or brick wall. Follow the Mounting Instructions below to complete the installa-
tion.
Required Materials:
• 3 hex head screws (Pos. 17)
• 3 washers (Pos. 16)
• 3 dowels (Pos. 15)
Required Tools:
• Power drill
• Suitable drill bit
• Wrench or ratchet for M6 hex heads
• Hammer (optional)
• Allen wrench 5 mm (item 3)
Mounting Instructions:
• Hold the drilling template at the position where you would like to mount the
camera.
• Mark the holes for drilling with a pencil or a sharp object, then remove the
drilling template.
• Drill the holes with the power drill where you just marked.
• Insert a dowel into each of the holes you just drilled. If required, use the
hammer to press the dowels into the holes.
• Slide a washer (item 5) over every hex head screw (item 6).
• Hold the camera against the wall. Make sure that the openings in the
mount's foot line up with the dowels.
• Insert the four screws (with washers) into the openings in the foot of the
camera and into the dowels.
• Tighten the screws using the wrench or ratchet (max. torque is 4 Nm/
2.95 lbf ft).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com