After Mounting The Camera - Mobotix D12 Manuals

D12 Camera Manual Part 1

2.16.4 After Mounting the Camera

Controlling the image position and the focus
• Remove the dome using a lint-free cotton cloth or the supplied plastic protec-
tion.
• Loosen the screw in the center of the camera using the supplied Allen
wrench (item 3) so that you can easily turn and tilt the sensor units.
• Display the camera images on a computer monitor, then turn and tilt the
sensor units until you have found the best position.
• Tighten the screws at the turn/tilt joints of the SecureFlex mount using the
Allen wrench (max. 4 Nm/2.95 lbf ft) to make sure that the position of the ca-
mera remains as set.
• If required, clean the lens' surfaces using a clean, lint-free cotton cloth.
• Check the image focus (tele lens L135 only) and the camera position on the
computer monitor. Please also see section 2.16, Adjusting the Tele Lens
Focus .
• Mount the dome again using a lint-free cotton cloth or the supplied plastic
protection. Make sure that you insert the dome into the housing with the
mark of the dome pointing towards the camera's PIR sensor, in order to pre-
serve the camera's weatherproofness!
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
79
/124
Max. torque for all
screws: 4 Nm
(2.95 lbf ft)