Mobotix D12 Manuals page 66

64
/124
Find the folded drilling
templates at the end of
the manual!
Make sure that the drill-
ing template is not scaled
down when printing!
Apply silicone sealant!
Cable length from wall:
min. 70 cm (28 in), min.
80 cm (32 in) when using
the Corner and Pole Mount
D12 Camera Manual Part 1
Use the supplied drilling template (at the end of this manual) to mark the position
for drilling the dowel holes and the holes through which the cables will be led later
on. When printing or copying the drilling template, make sure that it is not scaled
down!
• Use the supplied 10 mm dowels (item 15),
8x70 mm screws (item 17) and 9 mm dia.
washers (item 16) for mounting the Outdoor
Wall Mount to the wall!
• Before mounting the wall mount, attach the
supplied wall sealing (item 18) to its rear
(wall) side using some silicone sealant. If the
outdoor wall mount is mounted to a very
rough surface, the top of the wall mount
should also be sealed against the wall using
good-quality silicone sealant.
• The rectangular opening at the wall mount's
rear side is supposed to cover the wall outlet.
• If you do not use the pre-installed Ethernet
cable, make sure that the cable runs at
least 70 cm (28 in)
let (80 cm (32 in) when using the Corner and
Pole Mount, see section 2.11).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
from the wall or wall out-
www.mobotix.com • sales@mobotix.com