Starting The Camera Using The Factory Ip Address - Mobotix D12 Manuals

D12 Camera Manual Part 1

3.6 Starting the Camera Using the Factory IP Address

Under certain circumstances, you may have to reset the camera to its factory IP ad-
dress. This could be the case if the IP address of the camera has been lost or the
camera does not react to the last known IP address.
In order to start the camera using its factory IP address, hold the magnetic side of
the supplied custom tool onto the spot on the camera housing containing the L
button (the magnetic switch is mounted inside the camera housing):
• Remove the outer shell using the supplied
custom tool (see section 2.14, Dismantling the
Camera ).
• If the camera is powered on, disconnect the
power supply of the camera by unplugging
the corresponding cable.
• Reconnect power to the camera and observe
the LEDs.
• Wait until all LEDs are lighting up simultane-
ously.
• Now hold the magnetic side of the custom tool onto the spot above the mi-
crophone labeled L in the figure.
• Only release the custom tool when the camera plays a
ing").
The camera is now accessible again using its factory IP address (see label on
the camera housing).
If you use the camera's "L" button to load the factory network configu-
ration, this configuration is not automatically saved to flash memory.
Upon restarting the camera the next time
"L" button, the last stored network configuration will be used. To per-
manently store the new network configuration in the camera's flash
memory, open Admin Menu > Store ...
As opposed to resetting the camera using Admin Menu > Reset
configuration to factory defaults (see section 1.6.5), the users and
passwords defined in the camera will not be reset if the camera is
being booted using the factory IP address.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Microphone
Note
without using the camera's
Caution
"L" button
single sound ("Bo-
111
/124
Passwords and camera
settings will not be
changed!
Make sure you store the
factory network configu-
ration to the permanent
flash memory!
Users and passwords will
not be changed!