Table of Contents
Advertisement
68
/124
D12 Camera Manual Part 1
2.13 Finishing the Installation
2.13.1 Establishing a Connection to the Camera
Establish a connection to the camera as described in section 3.1.2, Establishing a
Connection to the Camera .
2.13.2 Adjusting the Lenses, Visual Check
Make sure that you see the live image of the camera on the monitor of your com-
puter or laptop. Now adjust the lenses one by one until you see the desired image
area on your monitor:
• Remove the camera dome using a lint-free cotton cloth.
• Release the lens' lock ring, adjust the image focus and tighten
the lock ring again.
• Make sure that the lenses' ribbon cables are properly secured.
• Make sure that the cable clamps are properly seated. This will pre-
vent the cable clamps from falling into the dome and obscuring parts of the
image once the camera has been mounted.
Caution (only applies to tele lenses)
Image Focus: Due to the lens effect of the dome, the focus of the tele
lens is shifting slightly once the dome has been mounted.
Before mounting the dome, the tele lens should be turned about 90°
in clockwise direction (as seen from the lens' front).
Make sure that you check the focus of the live image in your browser
with the dome installed and re-adjust the lens, if required.
• Mount the dome again using the cotton cloth and finally check the focus of
both lenses on the monitor.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Hide quick links:
Advertisement
Table of Contents
