Providing The Connections (Network/Isdn/Rs232); Connecting Additional Cat5 Cables - Mobotix D12 Manuals

D12 Camera Manual Part 1

2.3.6 Providing the Connections (Network/ISDN/RS232)

Once the camera position, the position of the cable outlets, and the method of
power supply have been decided upon, the cabling should be installed.
Before mounting the MOBOTIX D12, you should make sure that the network and
ISDN connections are properly tested, so that the proper functioning of the camera
is guaranteed.

2.3.7 Connecting Additional CAT5 Cables

If the MOBOTIX D12 should use a network (Ethernet) and an ISDN connection,
make sure to install a second CAT5 cable
28 in for D12 with outdoor wall mount)
order to prevent confusing this cable with the pre-installed network cable, the sec-
ond cable should have a different color (e.g.
be clearly marked as ISDN cable.
• Remove the M4x25 Allen screws of the cable cover (item 7) using the sup-
plied 3 mm Allen wrench and lift the cover out of its seat.
Note: If the cable cover cannot be removed
by hand, take a screwdriver to lift it out of its
seat. Insert the screw-
driver into the grooves
shown below
gently lift the cable
cover.
• Lead the CAT5 cable from the bottom of the camera housing through the
right-hand opening and guide it around the camera housing in counter-
clockwise direction (as seen from above). Make sure that this cable is run-
ning properly as shown in the figures below.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
(min. 50 cm/28 in for D12 only, 70 cm/
and to guide it into the camera housing. In
green
and
as in the figure) and it should
35
/124
3mm Allen wrench is in-
cluded in the delivery
Lead the cables through
the cable guides at the
outer rim of the housing