Maintenance
Fig. 107 – Track Installed Before Tensioning
15. Start the machine, open the engine compartment
and press the bottom of the track tension service
switch (N, Fig. 108), to set the track tension
cylinders into the operating (extended) position.
N
Fig. 108 – Track Tension Switch
16. Once the track tension cylinder has returned to
the operating (extended) position, re-install
cylinder stop (K, Fig. 109).
918468/EP0313
X
Fig. 109 – Tension Cylinder Stop
17. Operate the track drive forward/back to ensure
the track is properly seated. Adjust track
positioning if necessary.
18. Remove blocking and lower the machine to the
ground.
118
K
Printed in U.S.A.