Disengage Lift Arm Support - Gehl RT175 Operator's Manual

Operation
Z
X
Fig. 58 – Lift Arm Support Applied
c. Insert the retaining pin (Y, Fig. 59) through
the lift arm support (Z) so it passes under the
lift arm cylinder rod (X).
Z
Fig. 59 – Lift Arm Support Retaining Pin
9. Start the machine and lower the lift arm against
the lift arm support.
10. Shut off the engine.
11. Move the lift/tilt controls to verify that the
controls do not cause movement of the lift arm
and hitch plate.
12. Raise the safety bars/arm rests to apply the
parking brake and lock out the hydraulic
controls.
13. Unfasten the seat belt, remove the ignition key
and take it with you. Exit the machine using the
hand-holds.
918468/EP0313

Disengage Lift Arm Support

A second person on the outside of the machine
Y
is required to assist with disengaging the lift
arm support.
1. Start the engine and raise the lift arm as high as
it will go.
2. Move the drive controls to the neutral position.
3. Shut off the engine.
4. Move the lift/tilt controls to verify that the
controls do not cause movement of the lift arm
and hitch plate.
5. Raise the safety bars/arm rests to apply the
parking brake and lock out the hydraulic
controls.
X
6. Stay in the machine in the operator's position. A
second person, on the outside of the machine,
must:
Y
a. Remove retaining pin (Y, Fig. 60) securing
Fig. 60 – Lift Arm Support Retaining Pin
7. Have the second person stand away from the
machine and lower the lift arm to the ground.
82
WARNING
lift arm support (Z) in the support position.
Z
X
Y
Printed in U.S.A.