Disconnecting Attachments - Gehl RT175 Operator's Manual

Operation
3. Lower the lift arm so tabs (J) on the top of the
attachment plate are aligned just under hooks
(K) on the back of the attachment.
4. Tilt the attachment plate back until tabs (J) on
the top of the attachment plate are engaged
against hooks (K) on the back of the attachment.
5. Raise the lift arm slightly until the attachment is
hanging from hooks (K) and tabs (J) are firmly
inserted into the hooks. Tilt the attachment plate
back, if necessary, so the back of the attachment
is resting flat against the attachment plate.
6. Place the attachment lock into the locked
position (Fig. 63):
• Power-A-Tach® system hitch – Press the top
of hitch lock switch (I) until safety flags (H)
have moved all the way out.
• Manual attachment hitch – move hitch lock
lever all the way to the left (G).
Power-A-Tach® Quick Attach System Hitch In Locked
I
Manual Attachment Hitch In Locked Condition
G
Fig. 63 – Attachment Hitch – Locked
918468/EP0313
Condition
H
7. Make sure the locking pins (F, Fig. 64) are fully
engaged down through the holes in the
attachment.
Manual Attachment Hitch Shown, Power-A-Tach®
Quick Attach System Hitch Similar
Fig. 64 – Attachment Locking Pins
To prevent unexpected release of the
attachment from the hitch, be sure to properly
secure the hitch latch pins by hitch lock lever
(G, Fig. 63) all the way to the left (manual All-
Tach® hitch) or by ensuring that the safety flags
(H, Fig. 63) are all the way to the outside (Power-
A-Tach® hitch).
Locking pins (F) must be fully engaged through
the holes in the attachment frame before using
the attachment. The attachment could fall off if it
is not locked on the hitch and cause serious
injury or death.

Disconnecting Attachments

Position the attachment so that after
disconnecting the attachment will stand safely
and not tip over. Serious injury can occur if an
attachment tips over onto a person.
84
F
WARNING
WARNING
Printed in U.S.A.