Maintenance Schedule; Checks, Cleaning And Inspection - Gehl RT175 Operator's Manual

Maintenance

Maintenance Schedule

IMPORTANT:
Maintenance intervals apply to average operating conditions and loads. More frequent
maintenance may be required depending upon the level and type of use.
Log all maintenance as it is performed in the "Maintenance Log" on page 129.
NOTE:
Refer to the hour meter and the required maintenance display screen to determine maintenance
interval timing. See "Maintenance Interval" on page 102.

Checks, Cleaning and Inspection

Table 34: Checks Cleaning and Inspection
Service Procedure
Clean machine
Inspect machine for general wear/damage
Check bucket cutting edge
Check safety interlock system
Inspect tracks for damage/wear
Check automatic track tensioning
Check engine oil level and condition
Check coolant level and condition
Check hydraulic fluid level and condition
Check fuel level and fill if necessary
Check windshield washer system and wiper blade, if applicable
Check exhaust for excessive smoke emission
Check hydraulic cylinder piston rods for damage/wear; clean if necessary
Check ROPS structure (all fasteners must be installed and tightly secured)
Check water separator and drain water, if present
Check coolant system for leaks, dirt and debris
Check hydraulic hoses and tubes for cracks, leaks and/or debris
Check hydraulic tank, valves and cylinders for leaks and/or damage
Check coolant anti-freeze mixture
Check V-belt tension and condition
Check engine cover lock
Check engine idle
Clean radiator/oil cooler fins
Check hinge pins, joint bushings, pivot bolts and bearings
Check engine mounts
Check exhaust system for damage
Clean battery terminals
Check timing belt
Check fuel injectors
Check electrical system for damage, wire routing
918468/EP0313
10 Hours
(or daily)
100
Maximum Interval
250 Hours 500 Hours
(or every 6 (or annually)
months)
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Printed in U.S.A.
X
X
X
X
X
X
X