Track Replacement - Gehl RT175 Operator's Manual

Maintenance

Track Replacement

WARNING
Keeps hands clear from between the track and
the idler when installing tracks. Crushing of
body parts and amputation can result.
1. With the machine running and the drive system
not moving, remove tension cylinder stop (K,
Fig. 103) on the side on the machine with the
track to be replaced.
K
Fig. 103 – Tension Cylinder Stop
2. With the machine running and the drive system
not moving, open the engine compartment. Press
and hold the lock button (L, Fig. 104) on the
track tension service switch, and press the top
(M) of the switch to set the track tension
cylinders into the service (retracted) position.
918468/EP0313
M
L
Fig. 104 – Track Tension Switch
3. When the track tension cylinders are in the
service (retracted) position, shut off the machine.
4. Raise the machine about 150 mm (6"), so the
tracks are free to move.
Use solid support blocking. Never rely on jacks
or other inadequate supports when
maintenance work is being done. Never work
under any equipment supported only by jacks.
5. Use a pry bar to pry/guide the old track at (R,
Fig. 105) off the front idler wheel.
T
P
Q
S
Fig. 105 – Track Removal/Installation
116
WARNING
Printed in U.S.A.
R