Safety Symbol And Signal Words; Safety Alert Symbol; Signal Words; Machine Orientation - Gehl RT175 Operator's Manual

Introduction

Safety Symbol and Signal Words

This manual and decals on the machine warn of
safety hazards and should be read and observed
closely.
Manitou Americas, in cooperation with the
Society of Automotive Engineers, has adopted
this:

Safety Alert Symbol

This symbol is used throughout
this operator's manual and on the decals on the
machine. It identifies potential safety hazards,
which, if not properly avoided, could result in
injury. When you see this symbol in this manual
or on the machine, you are reminded to BE
ALERT! Personal safety is involved!

Signal Words

DANGER
The word "DANGER" indicates an imminently
hazardous situation, that, if not avoided, will
result in serious injury or death.
WARNING
The word "WARNING" indicates a potentially
hazardous situation that, if not avoided, could
result in serious injury or death.
CAUTION
The word "CAUTION" indicates a potentially
hazardous situation that, if not avoided, may
result in minor or moderate injury.
918468/EP0313
IMPORTANT:
The word "IMPORTANT" indicates
situations that can result in possible damage to the
machine.
NOTE:
The word "NOTE" indicates special or
particularly useful information.

Machine Orientation

"Right" and "left", as described in this manual, are
determined from a position sitting in the operator's
seat and facing forward.

Proper Machine Use

WARNING
Improper use of the machine can result in
property damage, injury or death.
The machine is designed only for moving earth,
coarse gravel or ballast and rubble. Use with
approved attachments is also allowed (See "Fields
of Application" on page 11). Use in any other way is
considered as contrary to the intended use.
Compliance with, and strict adherence to, the
conditions of operation, service and repair as
specified by the manufacturer, also constitute
essential elements of the intended use.
The machine was designed and built according to
the best available technology and approved safety
regulations in the countries where it is sold.
However, it is impossible to completely safeguard
against abusive, improper use. The operator must
always consider potential safety risks and hazards
during operation. Accident prevention regulations,
all other generally recognized regulations on safety
and occupational medicine, and all road traffic
regulations must be observed at all times.
The machine must be maintained in proper
operating condition. Any damaged or
malfunctioning parts must be repaired or replaced
immediately.
Any arbitrary modifications carried out to the
machine may relieve the manufacture of liability for
any resulting damage or injury.
8 Printed in U.S.A.