Alternate Transport Mode Cancel; Backup Alarm; Lift Arm Operation; Attachment Transport Position - Gehl RT175 Operator's Manual

Operation

Alternate Transport Mode Cancel

Limp modes are canceled if any of the following
occur:
• The parking brake is activated using the switch
on the control panel.
• The operator leaves the seat.
• The arm rests/safety bars are raised.
• The cab door is opened.
• The engine is shut down.
When limp mode is canceled through any one of
these actions, the drive system will remain disabled
until the error condition is corrected or limp mode is
re-activated.

Backup Alarm

The backup alarm (R, Fig. 48) is installed inside the
rear door.
Fig. 48 – Optional Backup Alarm
The backup alarm emits a tone whenever the drive
system is operated in reverse.
DANGER
Do not rely exclusively on the backup alarm to
alert others. Make sure that nobody is within the
work area when traveling in reverse.
918468/EP0313

Lift Arm Operation

Do not lift loads exceeding rated operating
capacity. See "Payloads/Capacities" on
page 34.

Attachment Transport Position

Always transport loads in transport position to
minimize the possibility of tipping or rollover
accidents and unstable balance conditions that
can cause loss of control.
Carry materials 200-300 mm (8-12") above the
ground, and adjust as necessary to clear obstacles.
Generally, carry the load as low as safely possible.
Tilt buckets back, as shown in Fig. "Transport
Position" on page 76, to prevent spilling material.
t
R
Fig. 49 – Transport Position
76
WARNING
WARNING
• 200-300 mm (8-12")
above ground,
adjusted to clear
obstacles.
• As low as safely
possible.
Printed in U.S.A.