Top Feed; Position Of The Needle Holder With Single Needle Sewing Machines - DURKOPP ADLER 887 Service Instructions Manual

3

Top feed

3.1

Position of the needle holder with single needle sewing machines

Angular position of
the needle holder
Needle thickness Nm
Rule:
The position of the needle holder is to be set in dependance to the
needle thickness according to the following chart.
70 - 110
1
–
Remove the thread guide.
–
Loosen screw (1) and turn the needle bar with the right groove
edge (2) to the needle bar axis (in sewing direction) and tighten
screw (1).
–
Bring the needle bar to the upper dead center and loosen the
screw of the needle holder through the bore (3) by using an Allen
key of 2.5 mm (4).
–
Turn the needle holder (5) according to the rule and tighten the
screw (1).
19
120 - 160 180 - 200
2
5
EN
4
3
5