Pptp Remote Dial-In - Draytek Vigor2130 series User Manual

Enable IPSec VPN
Pass-through (Server
inside your LAN)
Enable PPTP VPN
Service
Enable PPTP VPN
Pass-through (Server
inside your LAN)
4 . 8 . 2 P P T P R e m o
4 . 8 . 2 P P T P R e m o
You can manage remote access by maintaining a table of remote user profile, so that users can
be authenticated to dial-in via VPN connection.
The router provides access accounts for dial-in users.
Note: This page is similar to the page under User>>User Configuration.
If this checkbox is checked, the system firewall will allow
VPN (IPSec) remote access from WAN side to a VPN
device on the LAN. Type the IP address of the VPN device
in the field next to the checkbox.
If this checkbox is checked, the system firewall will allow
VPN (PPTP) remote access from WAN side to the router.
IP Address range for PPTP client – Specify an IP address
pool for the local private network that will be assigned to
PPTP clients. Note the values given here should not be the
same as IP address range for DHCP Client.
IP Address range for DHCP client – Display the range of
IP address assigned by DHCP server.
MPPE – Check this box to encrypt data transmission via
PPTP connection.
Pass Netbios Naming Packet – Check the box to make the
data transmission passing through the hosts on both sides of
VPN Tunnel while connecting.
Uncheck the box when there is conflict occurred between
the hosts on both sides of VPN Tunnel in connecting, such
function can block data transmission of Netbios Naming
Packet inside the tunnel.
If this checkbox is checked, the system firewall will pass
VPN (PPTP) remote access from WAN side to a VPN
server in the LAN. Type the IP address of the VPN server
in the field next to the checkbox.
t e D i a l - i n
t e D i a l - i n
170
Vigor2130 Series User's Guide