Draytek Vigor2130 series User Manual page 248

Item
Destination IP / Choose
PC
Destination Subnet/
Choose Subnet
Source Start Port
Source End Port
(optional)
Destination Start Port
Destination End Port
(optional)
Action
E x a m p l e :
E x a m p l e :
Refer to the following example.
1. Use TSPC mode to connect to IPv6 network.
PC get ipv6 IP: 2001:5c0:1503:7400:30e4:139d:53c8:3a1e
2. Connect PC to http://www.ipv6.org/ with IPv6 IP address.
A message will appear from the web page:
You are using IPv6 from 2001:5c0:1503:7400:30e4:139d:53c8:3a1e
3. Set firewall rule to block all TCP traffic from this IP address.
4. Open IPv6 >> IPv6 Firewall Setup and press Add New Rule.
Description
Type the IP address here if you choose Single as
Destination IP Type. Or click Choose PC to select an Ipv6
address.
Type the subnet mask here if you choose Subnet as
Destination IP Type. Or click Choose Subnet to select an
Ipv6 subnet.
Type a value as the source start port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the source end port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the destination start port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the destination end port. Such value will be
available only TCP/UDP is selected as the protocol.
Set the action that the router will perform for the packets
through the protocol of IPv6.
ACCEPT – If the IPv6 packets fit the condition listed in
this page, the router will let it pass through.
DROP- If the IPv6 packets fit the condition listed in this
page, the router will block it.
Welcome to the IPv6 Information Page!
240
Vigor2130 Series User's Guide