Bind Ip To Mac - Draytek Vigor2130 series User Manual

To add a new police route, please click Add to open the following page.
Available settings are explained as follows:
Item
Enable
Source IP Address
Subnet Mask
Destination IP Address
Subnet Mask
Gateway IP Address
Interface
Do NAT for Source
Subnet
Status
After finishing all the settings here, please click OK to activate them.
4 . 2 . 8 B i n d I P t
4 . 2 . 8 B i n d I P
This function is used to bind the IP and MAC address in LAN to have a strengthening control
in network. When this function is enabled, all the assigned IP and MAC address binding
together cannot be changed. If you modified the binding IP or MAC address, it might cause
you not access into the Internet.
Click LAN and click Bind IP to MAC to open the setup page.
Vigor2130 Series User's Guide
o M A C
t o M A C
Description
Check it to enable such route.
Type the source address for such policy route.
Type the subnet mask for such policy route.
Type the destination address for such policy route.
Type the subnet mask for destination for such policy route.
Type the gateway IP address for the policy route.
Choose an interface used by such policy route.
Except LAN option, any option selected as the Interface
allows you to enable or disable such feature.
Display the status of the policy route.
105