Draytek Vigor2130 series User Manual page 132

Choose IPv4 as the Frame Type. You will see IP Parameters on the bottom of the page.
If you choose ICMP as IP Protocol Filter, you will get the page as the following:
Available settings are explained as follows:
Item
Source IP
Source IP Address
Source IP Mask
Dest IP Filter
0: ARP/RARP frames where the protocol address space is
equal to IP (0x800) must not match this entry.
1: ARP/RARP frames where the protocol address space is
equal to IP (0x800) must match this entry.
Any: Any value is allowed.
Description
Specify the Source IP filter for this ACE.
Any: No source IP filter is specified.
Host: Source IP filter is set to Host. Specify the source IP
address in the Source IP Address field that appears.
Network: Source IP filter is set to Network. Specify the
source IP address and source IP mask in the Source IP
Address and Source IP Mask fields that appear.
Type the Source IP Address here. This option is available
when you choose Host or Network as Source IP.
Type the Source IP Mask here. This option is available only
when you choose Network as source Source IP.
Specify the destination IP filter for this ACE.
124
Vigor2130 Series User's Guide