Camera Control Unit (Ccu) Rear Panel - Sony MCC-1000MD Instructions For Use Manual

10.
AUTO (automatic exposure) button (page
34)

Camera control unit (CCU) rear panel

Warning
Using this unit for medical
purposes
The connectors on this unit are not isolated.
Do not connect any device other than one
which conforms to IEC 60601-1 standards.
When an information technology device or
AV device that uses an alternating current is
connected, current leakage may result in an
electric shock to the patient or operator.
If use of such a device is unavoidable,
isolate its power supply by connecting an
isolation transformer, or by connecting an
isolator between the connecting cables.
After implementing these measures,
confirm that the reduced risk now conforms
to IEC 60601-1 standards.
11.
BLUE (B-gain) knob (page 33)
12.
RED (R-gain) knob (page 33)
Caution
Do not come into contact with the terminals
of the rear panel connectors and patients at
the same time.
Doing so may result in a generation of
voltage that can be harmful to patients if the
unit is malfunctioning.
Always disconnect the power cord before
connecting and disconnecting connectors.
1.
CAMERA connector (page 25)
2.
3D-SYNC IN (3D-SYNC input)
connector,
SYNC output) connector (BNC type)
(page 53)
3.
VIDEO (composite video) output
connector (BNC type) (page 27)
4.
Remote contact switch connector 1, 2
(stereo mini jack) (page 52)
5.
Equipotential ground connector
Used to make an equipotential ground
connection.
6.
- (power) connector (page 28)
7.
RS-232C connector (D-sub 9-pin)
(page 54)
8.
S VIDEO output connector (mini
DIN 4-pin) (page 27)
22
3D-SYNC OUT (3D-