Adjusting Console Lights; Setting Default Xfade And Delay Times; Setting Numeric Timeout; Enabling Cuelist Confirmations - Lightwave Research Status Cue User Manual

Adjusting Console Lights

To adjust Littlite brightness, use the
intensity balance between the two lights, use the
balance). Refer to Figure B.9.

Setting Default Xfade and Delay Times

The default Xfade and Delay times are the values that automatically appear when new
Scenes and Sequences are created. To set default times, click in the
Default Delay

Setting Numeric Timeout

Numeric timeout is the time between a numeric key press (in the CONTROL group) and
the time the Console automatically accepts the input (key press). This feature is used when
selecting fixtures. To set appropriate time, click in the
desired time. Refer to Figure B.9.
Notes: Numeric Timeout can be disabled by deselecting its

Enabling CueList Confirmations

CueList confirmations are provided to ensure cues are recorded and to close a CueList. To
enable or disable CueList confirmations, click the following check boxes (Figure B.9):
•
Beep when recording Cues
recorded
•
Prompt to close CueList
instead of instantly closing the CueList

Enabling and Disabling Startup Animation

To enable or disable the animation at Status Cue startup, click the
check box. Refer to Figure B.9.
B-12 Status Cue User's Manual
boxes and then type the desired times. Refer to Figure B.9.
is necessary to press the <
number is entered.
- provides a confirmation dialogue box to close a CueList
Console Light Intensity
Balance
ENTER > key in the CONTROL group after a fixture
- the system speaker beeps to confirm when a new cue is
scroll bar. To adjust the
scroll bar (the middle is equal
Default Xfade
box and enter the
Numeric Timeout
box. When disabled, it
Enable
Show Startup Animation
or the