Fader Action - Lightwave Research Status Cue User Manual

Fader Action

The following options are available for the Fader Presets in the
field:
• - enables fader control of the Preset's
Dimmer
is activated by the button.
• Dimmer, Auto-Latch
and moving the Fader past 0% (bottom) turns the Preset on and moving the
Fader back to 0% turns it off.
Note: if the fader is accidentally bumped, the Fader level will take precedence
over the recorded, so light output could be very low.
• Manual Xfade - enables the fader to manually Xfade Steps of a Sequence (in
the Preset). Moving the fader to 0% (bottom) starts the first Step, when the
fader reaches 100% (top) the next Step will engage. Repeat the process for
additional Steps.
Note: the Sequence proceeds to the next Step, you can not go backward.
• Delay - overrides the
of the Preset. Moving the fader up increases
Delay
and moving the fader down decreases
• Rate - overrides the
position equal to the programmed
up to 50% and moving the fader down decreases
• Relative Rate - overrides
When the fader is at 50%, the Sequence will run at the programmed
Moving the fader above and below 50% increases and decreases
Notes: when the Preset is turned on and
Fader level immediately. You must override the existing recorded Rate by
raising or lowering the fader above 50% to gain control.
- enables fader control of the Preset's
Delay (s) in the Preset and allows the fader to control the
Delay
Rate in the Preset when the fader is first moved to a
. Moving the fader up increases
Rate
Rate and sets Rate
Relative Rate
Fader Action
Constructs after the Preset
Dim
Dim Constructs
(slows movement)
Delay
(quickens movement).
Rate up to 50%.
according to the fader position.
Rate
is used, it will run at the
Chapter 7 Songs 7-11
7
Rate
.
Rate
.