Editing; Naming A Sequence - Lightwave Research Status Cue User Manual

Editing

Use the following subsections to edit Sequences:
• "Adding New Steps" on page 6-4
• "Inserting New Steps" on page 6-5
• "Naming a Sequence" on page 6-7
• "Naming Steps" on page 6-6
• "Editing" on page 5-4
• "Copying and Pasting Fixture Constructs" on page 6-8
• "Cutting, Copying, and Pasting Steps" on page 6-8
• "Dragging and Dropping Steps" on page 6-9
• "Dragging and Dropping a Scene Into a Step" on page 6-9
• "Setting, Inserting, and Getting Sequences Into Presets" on page 6-9
• "Deleting Steps" on page 6-9
Adding New Steps
To add a new Step to a Sequence, complete the following procedure:
Note: the <
6-4 Status Cue User's Manual
1. Select and scroll through the open Sequences by pressing the <
in the OBJECT group. Alternately, select an open Sequence from the
Window drop-down menu.
2. Press the < > key in the OBJECT group (Figure 6.1).
STEP
3. Press the < NEW > key in the MEMORY group (Figure 6.4). A new Step
will be added after the last Step.
4. Repeat item 3 to add additional Steps to the Sequence.
STEP > key will remain flashing until it is turned off by pressing the
< SEQ > key. This allows the addition of new Steps by only pressing the
< NEW > key.
SEQ > key