Copying And Pasting Fixture Constructs; Cutting, Copying, And Pasting Steps - Lightwave Research Status Cue User Manual

Copying and Pasting Fixture Constructs

To quick copy and paste a Construct parameters from one Step to another,
complete the following procedure.

Cutting, Copying, and Pasting Steps

To cut, copy, or paste a Step, complete the following procedure:
6-8 Status Cue User's Manual
1. Select the Step to copy from (source Step).
2. Select the fixtures to copy (source fixtures). Refer to "Selecting Fixtures"
on page 5-5.
3. Press the < COPY > key in the MEMORY group.
4. Select the Step to paste the Constructs to (destination Step).
5. Press the < > key in the MEMORY group. This brings up the
COPY
Selected Fixture(s)
dialogue box. Refer to Figure 6.7.
Figure 6.7. Paste Selected Fixture(s) Dialogue Box
6. Press the < ENTER > key or the <
Alternately, use the mouse and click
1. Select the Step(s) to copy by clicking it.
2. Select either Cut or
3. Select a Step to place the Step (in memory) before.
4. Select from the
Paste
dialogue box. The Steps' names will appear in the
CANCEL > key in CONTROL group.
or
OK
Copy from the Edit drop-down menu.
drop-down menu.
Edit
.
Cancel
Paste