Ir Control Switching - Barco HDX series Installation Manual

13. Projector Control

13.6 IR Control switching

What can be done ?
Each IR receiver inside the projector can be activated or deactivated. When an IR receiver is deactivated, no IR signal send to this
IR receiver will be processed.
How to activate or deactivate
1. Press Menu to activate the menus and select Projector Control → IR control.
Image 13-48
Main menu, projector control
Image 13-50
IR control
2. Use the ▲ or ▼ key to select the desired IR control and press ENTER to check checkbox.
Checked : IR receiver is enabled and can receive and process commands send by the remote control.
Not checked : IR receiver is disabled and not receive any command.
248
Image 13-49
Projector control, IR control
R5905032 HDX SERIES 01/06/2011