Barco HDX series Installation Manual page 68

5. Getting started
Ind. Key name
13 Picture controls
14 PHASE
15 FREEZE
16 TEXT
17 ENTER
18
Cursor keys
19 EXIT
20 WINDOW
21 PIP
22 RC Operating indication
Table 5-1
64
Description
Use these buttons to obtain the desired picture level.
Used to remove the horizontal instability of the image (usually for RGB source). It adjusts
the phase of the pixel sampling clock relative to the incoming signal.
To freeze the actual projected image.
Toggle key to activate or deactivate on screen text boxes while adjusting a setting.
When adjusting one of the image controls, e.g. during a meeting, the normally displayed
bar scale can be deactivated by pressing 'TEXT' key first. To re-display the bar scale
on the screen, press 'TEXT' key again. When TEXT is 'off', no adjustment menu's
will be displayed on the screen when entering the adjustment mode. All menus and
adjustments remain active on the local LCD panel.
Key to confirm an adjustment or selection in the adjustment mode.
To make menu selections when in the adjustment mode
Key to go one menu stage higher than the actual position when in the adjustment mode.
Selection of the active window "Main" or "PiP"
Direct access key for picture in picture selection.
Lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
R5905032 HDX SERIES 01/06/2011