Barco HDX series Installation Manual page 54

3. Physical installation
3. Turn in the rigging clamps (A) into the rigging points using a 17 mm open ended spanner. Place a washer between the clamp
and the rigging point.
Image 3-49
Mount rigging clamps
Warning: Always use four (4) rigging points, equally spread, to suspend the projector.
4. Place all four rigging clamps in open position.
5. Place the projector (upside down) under the truss installation and lower the truss until the support bars of the truss are nearby
the rigging clamps mounted on the projector.
Image 3-50
Mount to truss
6. Lift up the projector and hook the four rigging clamps over the support bars of the truss.
50 R5905032 HDX SERIES 01/06/2011