Barco HDX series Installation Manual page 337

5. If necessary, adjust the skew of the stacked projector with respect to the reference projector by turning the Hand screw in or out.
The hand screw is located at smallest side of the carrying handle (front or back). Adjust until the outline of the hatch pattern is
most symmetric with the reference hatch pattern.
Skew
Image E-8
Stacked projectors, skew
6. Shift the hatch pattern horizontally and vertically until the outline of the hatch pattern is most symmetrically placed with respect
to the reference hatch pattern.
Note: Note that the "Shift" function is motorized, which means that you have to access the projector software, via the local
keypad or remote control unit, to operate the "Shift" function.
Shift
Image E-9
Stacked projectors, shift
7. Zoom the hatch pattern in or out until the outline of the hatch pattern matches exactly the outline of the reference hatch pattern.
Note: Note that the "Zoom" function is motorized, which means that you have to access the projector software, via the local
keypad or remote control unit, to operate the "Zoom" function.
Zoom
Image E-10
Stacked projector, zoom
8. If necessary, repeat from step 2 until the hatch pattern of the stacked projector is perfectly aligned with the hatch pattern of the
reference projector.
In case of a triple stacked table mount projector configuration adjust and align first the bottommost projector
(reference), than the projector in the middle and finally the uppermost projector.
R5905032 HDX SERIES 01/06/2011
E. Stacking HDX projectors
333