Adjusting The Input Balance - Barco HDX series Installation Manual

9. Image
9.3.7.2

Adjusting the input balance

How can it be done ?
To balance the three color signals of a particular source there are conditions; in fact we must know the black and the white level of
the source i.e. :
1. The source in question must be able to generate a white signal, ideally a 100% white (background) full screen pattern
2. The source in question must be able to generate a black signal, ideally a 100% black (background) full screen pattern
A
Image 9-30
White balance : In the projector, we will set the contrast for each color until we get a 100% light output picture when projecting a
100% white image (image A)
Black balance : In the projector, we will set the brightness for each color until we get a 0% light output picture when projecting a
100% black image (image B).
The changeover from min to max is indicated by the apparition of bright spots also called "digital noise"
An alternative to a full screen White/black pattern is the standard gray scale pattern, the white bar will be used
for white balance and the black bar for black balance.
Image 9-31
How to adjust
1. Press Menu to activate the menus and select Image → Image Settings → Input Balance.
Image 9-32
Main menu, Image
128
B
Image 9-33
Image adjustments
R5905032 HDX SERIES 01/06/2011