Figure 3-17: Cutout Dimensions; Afl2-W15B-H61; Panel Mounting - IEI Technology afl2-w15b-h61 Introductory Manual

3.12.2 Panel Mounting

To mount the AFL2-W15B-H61 flat bezel panel PC into a panel, please follow the steps
below.
Step 1: Select the position on the panel to mount the flat bezel panel PC.
Step 2: Cut out a section corresponding to the size shown below. The size must be
smaller then the outer edge.

Figure 3-17: Cutout Dimensions

Step 3: Slide the flat bezel panel PC through the hole until the frame is flush against the
panel.
Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (
Step 6: Insert the panel mounting clamps into the holes of the panel mounting brackets
( F igure 3-18
9 0 9 H

AFL2-W15B-H61.

Page 34
). There are a total of 4 panel mounting clamps for
AFL2-W15B-H61
F igure 3-18 ).
9 0 8 H