Panel Mounting; Figure 3-9: S19A-Qm87I Cutout Dimensions; Figure 3-10: S24A-Qm87I Cutout Dimensions - IEI Technology S24A-QM87 User Manual

S19A/S24A-QM87i Marine Panel PC

3.5.1 Panel Mounting

To mount the S19A/S24A-QM87i flat panel PC into a panel, please follow the steps below.
Step 1: Select the position on the panel to mount the flat panel PC.
Step 2: Cut out a section from the panel that corresponds to the rear panel dimensions
of the flat panel PC. Take care that the panel section that is cut out is smaller
than the overall size of the metal frame that surrounds the flat panel PC but just
large enough for the rear panel of the flat panel PC to fit through.

Figure 3-9: S19A-QM87i Cutout Dimensions

Figure 3-10: S24A-QM87i Cutout Dimensions

Step 3: Slide the flat panel PC through the hole until the aluminum frame is flush against
the panel.
Page 23