Figure 3-19: The Rack/Cabinet Bracket; Afl2-W15B-H61 - IEI Technology afl2-w15b-h61 Introductory Manual

NOTE:
When purchasing the cabinet/rack installation bracket, make sure it is
compatible with both the AFL2-W15B-H61 flat bezel panel PC and the
rack/cabinet into which the AFL2-W15B-H61 is installed.
Step 9: Slide the rear chassis of the AFL2-W15B-H61 flat bezel panel PC through the
rack/cabinet bracket until the aluminum frame is flush against the front of the
bracket ( F igure 3-19).
9 1 1 H

Figure 3-19: The Rack/Cabinet Bracket

Step 1: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 2: Secure the two rack mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (
Step 3: Insert the rack mounting clamps into the holes of the rack mounting brackets
( F igure 3-20
9 1 3 H

AFL2-W15B-H61.

Step 4: Tighten the screws that pass through the rack mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel.
Page 36
). There are a total of 4 rack mounting clamps for
AFL2-W15B-H61
F igure 3-20 ).
9 1 2 H