Table of Contents
Advertisement
Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,
to configure the jumpers or plug in added peripheral devices, ground
themselves first and wear and anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1:
Unpack the flat bezel panel PC.
Step 2:
Install the HDD.
Step 3:
Install the CF card.
Step 4:
Install the RFID reader. (optional)
Step 5:
Configure the system.
Step 6:
Connect peripheral devices to the flat bezel panel PC.
Step 7:
Mount the flat bezel panel PC.
3.4 HDD Installation
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To install the HDD into the AFL2-W15B-H61, please follow the steps below:
Step 1:
Remove two (2) retention screws from the HDD cover (
Page 22
AFL2-W15B-H61
Step 0:
F igure 3-1).
8 8 6 H
Advertisement
Chapters
Table of Contents
