Figure 7-4: Ddr So-Dimm Module Installation - IEI Technology afl2-w15b-h61 Introductory Manual

Step 1: Follow all anti-static procedures. See Section
Step 2: Turn off the power. See Section
Step 3: Remove the back cover. See Section
Step 4: Remove the internal aluminum back cover. See Section
Step 5: Locate the DDR3 SO-DIMM on the motherboard.
Step 6: Remove the DDR3 memory module by pulling both the spring retainer clips
outward from the socket.
Step 7: Grasp the DDR3 memory module by the edges and carefully pull it out of the
socket.
Step 8: Install the new DDR3 memory module by pushing it into the socket at an angle
( F igure 7-4).
1 0 1 3 H
Step 9: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
Step 10: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.

Figure 7-4: DDR SO-DIMM Module Installation

Step 11: Replace the internal aluminum cover and secure it to the chassis using six (6)
retention screws.
Page 126
AFL2-W15B-H61
7 .2.
1 0 0 9 H
7 .3.
1 0 1 0 H
7 .4.1 above.
1 0 1 1 H
7 .4.2 above.
1 0 1 2 H
F igure 7-4).
1 0 1 4 H