Panel Mounting; Figure 3-12: Cutout Dimensions - IEI Technology AFL3-W07A-BT-N1/PC/2G-R20 User Manual

AFL3-W07A-BT Panel PC

3.7.2 Panel Mounting

To mount the AFL3-W07A-BT flat bezel panel PC into a panel, please follow the steps
below.
Step 1:
Select the position on the panel to mount the flat bezel panel PC.
Step 2: Cut out a section corresponding to the size shown below. The size must be
smaller then the outer edge.

Figure 3-12: Cutout Dimensions

Step 3: Slide the flat bezel panel PC through the hole until the frame is flush against the
panel.
Step 4: Insert a M5*50 screw into the screw hole on the side of the panel mounting
bracket. Then, install the following components onto the screw in sequence.
See Figure 3-13.
Sequence
1
2
3
Item Photo
Spring
Nut
Plastic
cap
Instruction
Install a spring onto the screw.
Tighten a nut until the spring is
compressed enough for plastic cap.
Tighten a plastic cap onto the end of
screw thread.
Page 25