Before You Begin; Prepare The Required Hardware And Tools - Ruckus Wireless ZoneFlex 2741 802.11g Getting Started Manual

Before You Begin

Prepare the Required Hardware and Tools

Figure 2.
Bottom cover
White P-clip cable
clamp
3
Before You Begin
Before installing and setting up the Access Point, Ruckus Wireless recommends that you
first complete the following pre-installation tasks.
Prepare the Required Hardware and Tools
You must supply the following tools and equipment:
A notebook computer running on Windows XP/2000 and installed with one wireless
■
802.11b/g network card and one Ethernet card
6mm flathead screwdriver
■
6mm Phillips screwdriver
■
10mm ratchet wrench
■
3mm Phillips screwdriver (if you will be using DC power)
■
Electric drill with 8mm drill bit (if mounting on a flat surface)
■
4
Mounting kit contents
DC terminal block
Machine screw (2
pieces)
Black solid rubber
stopper (2 pieces)
Machine screw with
washer (3 pieces)
Rubber O-ring (1
black and 1 green)