Step 3: Connect The Access Point To The Network - Ruckus Wireless ZoneFlex 2741 802.11g Getting Started Manual

Deploying the Access Point

Step 3: Connect the Access Point to the Network

Step 3: Connect the Access Point to the Network
In this step, you will connect the Access Point from its mounting location to the network.
The connections required for your installation depend on the power sources that you are
using. Figure 25
that uses both PoE and DC power as power sources.
Figure 25.
1
1 Router or switch
2 Ethernet (CAT5) cable
3 PoE injector
4 PoE injector power adapter
5
Ethernet (CAT5) cable
6
Ethernet surge protector
7
Ground wire
38
shows an example of the connections required for a typical installation
Typical installation components using both PoE and DC power sources
3
2
4
11
6
5
7
8
8 Ground rod
9 Drip loop
10 Outdoor-rated FTP cable
11 ZoneFlex Outdoor Access Point
12 DC cable
13 DC battery
12
13
10
9